Starke Triple P Ceramic Prep Polish is the Step 3 finishing polish for gelcoat and paint when you're going to ceramic coat. It's engineered to help Starke Repel Pro and Starke Liquid THOR bond. It's also used on already-coated boats to level high spots and to prep for a maintenance topcoat.

These directions follow STARKE's published product pages and Technical Data Sheets. Always read the label and Safety Data Sheet on your bottle, and test a small area first.

What you'll need

Before you start

Correct the paint first (Starke Level R Heavy Cut Compound and Starke Elevate Medium Cut Compound as needed). Wash so no compound residue is left on the panel.

Step by step

  1. Work one small section at a time.
  2. Polish until the product refines down to a light haze.
  3. Remove the residue with a clean microfiber.
  4. Then wipe with Starke Surface Prep Alcohol Spray before coating. Use Surface Prep after Triple P, not before. This is STARKE's preferred protocol.
  5. Apply your ceramic coating.

Coating directly over Triple P

STARKE also allows coating straight over Triple P with no Surface Prep wipe, but only when all of these are true:

  • You coat within 30–60 minutes.
  • You don't use any alcohol or solvent wipe, which would strip Triple P's silica film.
  • All Triple P haze has been removed.
  • You're coating with Repel Pro or THOR.
  • The boat is about 5 years old or newer, without severe oxidation.

If you can't coat soon after, use the Surface Prep method above.

Other uses

Safety

  • The STARKE SDS lists Triple P as DANGER: may be fatal if swallowed and it enters the airways, and causes serious eye irritation.
  • Wear safety glasses and nitrile gloves. Use with ventilation, not in confined areas.
  • Keep the product moist while polishing to avoid dust.

Watch it done

Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.

16 noviembre 2026 — Marine Detail Supply Team