Starke Hyper Hold Pro is an SiO2 polymer sealant for marine paint and gelcoat. It can be applied in warm or cold climates and is the usual finish after a Starke Finish R Hybrid Finishing Polish polish.

These directions follow STARKE's published product pages and Technical Data Sheets. Always read the label and Safety Data Sheet on your bottle, and test a small area first.

What you'll need

Before you start

The surface should be fully polished and free of residue. If needed, wipe the gelcoat down with a panel prep solution or a Dawn wash first.

Step by step

  1. Put a few pea-sized drops on the pad.
  2. Set the DA to speed 1–2 and work about 2–3 sq ft at a time.
  3. Lay it on thin, in one even coat. The thinner the coat, the easier it is to remove. This is not a polishing step, so don't keep working it in.
  4. Let it dwell at least 20–30 minutes. It can sit overnight and still wipe off easily.
  5. Buff off with a clean microfiber until clear and streak-free.

Applying by hand tends to lay the sealant on thicker, which makes removal harder. One even coat is enough.

How often to reapply

Expect about 3–6 months in the Florida sun. Reapply every 3–6 months, and top up between applications with Starke Replenish Silica Spray. Wash with Starke Ultra Clean SiO2 Soap or Starke Salt Clean Boat Wash.

Safety

  • The STARKE SDS lists Hyper Hold Pro as DANGER: combustible liquid, causes skin and serious eye irritation, may cause an allergic skin reaction, and may damage organs through prolonged or repeated exposure.
  • Wear safety glasses and nitrile gloves. Use in a well-ventilated area, not in confined spaces.
  • Keep away from heat and flame.
  • California Prop 65 warning.

Watch it done

Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.

November 16, 2026 — Marine Detail Supply Team