Starke Venom Water Spot and Stain Remover is a gel that breaks down water spots, minerals, rust and tannin stains. It's made for ceramic-coated surfaces, gelcoat, stainless, painted metal and powder coat when used as directed and rinsed thoroughly.

These directions follow STARKE's published product pages and Technical Data Sheets. Always read the label and Safety Data Sheet on your bottle, and test a small area first.

Keep it off these surfaces

  • Electronics screens, MFDs and chart plotters. It permanently strips their UV coating.
  • Raw or bare aluminum. It can cause whitening.
  • Tinted, coated or anti-glare glass.
  • Test first on anodized surfaces and on any glass.

Before you start

  • Put on chemical-resistant gloves and eye protection.
  • Wash first so grit doesn't scratch.
  • Work on a cool surface, ideally morning or evening, out of direct sun. Hot surfaces can etch.
  • Never let Venom dry on the surface. It can damage metals, plastics and glass.

Spot treatment (water spots, stainless)

  1. Apply a little Venom to a clean microfiber.
  2. Work 2 ft × 3 ft sections with even strokes, vertically then horizontally. It usually works right away.
  3. Rinse each section with water before moving on.

Strip wash (ceramic-coated hulls)

  1. Put about 4 oz of Venom in a bucket and add just enough water to cover the brush head.
  2. Pre-wet the hull. Never apply to a dry surface.
  3. Dip the brush and add one extra bead of Venom to the brush head.
  4. Scrub in overlapping patterns with moderate pressure.
  5. Let it dwell about 5 minutes, without letting it dry.
  6. Rinse thoroughly. Repeat for severe or tannin stains, rinsing between applications.

STARKE recommends a monthly strip wash on ceramic-coated boats, followed by Starke Replenish Silica Spray.

Rust

  • Light rust: work Venom in with a microfiber.
  • Stubborn rust: apply the gel directly so it clings, and agitate with a soft brush if needed.
  • Rinse after each application and repeat as needed.

Safety

  • Corrosive. The STARKE SDS lists Venom as DANGER: toxic if swallowed or inhaled, and causes severe skin burns and eye damage. It contains sulfuric acid.
  • Wear nitrile or chemical-resistant gloves and safety glasses with side shields. A face shield is recommended.
  • Use with good ventilation.
  • Never mix Venom with bleach-based cleaners such as Starke Mildew Clean.
  • Don't let rinse water run into the waterway. Collect it per local rules.
  • Store away from heat and sun.

Watch it done

Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.

November 16, 2026 — Marine Detail Supply Team