How to Apply GTECHNIQ Marine Ceramic Base and Top
GTECHNIQ Marine Base and GTECHNIQ Marine Top are GTECHNIQ's two-layer marine ceramic coating for gelcoat and painted surfaces above the waterline. Base goes on first; Top bonds to Base, or directly to gelcoat or topcoat on its own. GTECHNIQ rates Base at up to 18 months or more, depending on use and conditions.
These directions follow GTECHNIQ's published manuals, data sheets and product pages. Always read the label, manual and Safety Data Sheet for your product, and test a small area first.
Products in this guide
What you'll need
- GTECHNIQ Marine Base and GTECHNIQ Marine Top
- GTECHNIQ Marine Panel Wipe
- Clean microfiber towels, such as Autofiber Ultra Plush Microfiber towels or the Dual Pile Microfiber 36 Pack
- The application pad supplied with the coating
- Gloves and eye protection
Before you start
- Polish the surface to remove imperfections. The coating locks in whatever is underneath it.
- Degrease with GTECHNIQ Marine Panel Wipe and a clean microfiber to remove every trace of polish residue. GTECHNIQ says the coating bonds best to surgically clean surfaces.
Step by step (same for Base and Top)
- Soak the application pad with coating.
- Spread it over an area no larger than 2 ft × 2 ft.
- Remove the residue with a clean microfiber.
- Move to the next section, overlapping slightly.
Coverage is about 0.5–0.7 ml per sq ft, depending on how porous the gelcoat or topcoat is.
Layering and cure
- Base then Top: wait 4 hours after finishing Base before applying Top, then allow at least 12 hours for both to cure.
- Base or Top on its own: allow at least 12 hours to cure.
Maintenance
- Wash with a pH-neutral boat wash such as GTECHNIQ Marine UV Wash, using soft mitts or microfiber.
- Avoid abrasive cleaners.
- Top up periodically with GTECHNIQ Marine Ceramic Fast Coat.
Opened bottles should be used within 3 months; unopened, within 12 months.
Safety
- Marine Base is highly flammable. Keep it away from heat, sparks and flame, and work with good ventilation.
- Marine Top may be fatal if swallowed and it enters the airways.
- Wear protective gloves and eye protection. Wear a suitable mask where you could breathe in vapor.
Watch it done
Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.




