How to Apply Starke Liquid Kraken Graphene Coating
Starke Liquid Kraken is a marine-grade graphene coating for gelcoat, marine paint, powder coat and glass. STARKE says it reduces water spotting by about 50%. It can be used as a base layer, a top layer over Starke Repel Pro, or on its own.
These directions follow STARKE's published product pages and Technical Data Sheets. Always read the label and Safety Data Sheet on your bottle, and test a small area first.
Products in this guide
What you'll need
- Starke Liquid Kraken
- A suede coating applicator
- Two clean microfiber towels per section, such as Autofiber Ultra Plush Microfiber towels or the Dual Pile Microfiber 36 Pack
- Starke Surface Prep Alcohol Spray
- Nitrile gloves and safety glasses
Before you start
- Never coat over oxidation. The surface must be fully corrected and decontaminated first.
- Wipe with Starke Surface Prep Alcohol Spray until oil-free. This removes polishing residue that would stop the coating from bonding.
- Temperature: 60–90°F. Do not apply below 50°F.
Step by step
- Put 4–10 drops on the suede applicator, depending on the size of the area.
- Apply in thin, consistent strokes. The coating looks dark while it's wet. That's normal.
- Watch for the "corduroy" pattern: when your application strokes become clearly visible across the surface, it has flashed and it's time to level.
- Level and remove with two clean microfibers: the first to remove, the second as an insurance towel to catch high spots.
Layering
- Kraken over Kraken: apply the second layer within 6–18 hours.
- Kraken over Starke Repel Pro: let Repel Pro sit 1.5–3 hours, then apply Kraken within 1.5–6 hours (about 10 hours at most).
- For a 25 ft boat, plan on 1–2 bottles per layer.
Cure
- No water contact for 24–48 hours.
- No soap washes for 5–7 days.
- Full hardness takes 7–14 days.
Maintenance
- Wash with a pH-neutral soap such as Starke Pure Clean Boat Soap or Starke Ultra Clean SiO2 Soap, and use Starke Salt Clean Boat Wash after salt runs. Don't use soaps that contain wax.
- Use microfiber wash mitts, not brushes, on smooth surfaces.
- Rinse with deionized or RO water when you can.
- Every 9–12 months: a Starke Venom Water Spot and Stain Remover strip wash, a quick Starke Triple P Ceramic Prep Polish polish, a Starke Surface Prep Alcohol Spray wipe, then one fresh layer of topcoat.
For a graphene refresh between services, STARKE's data sheet names Starke Reboot Graphene Maintenance Spray. Expect 12–24 months of protection from a Kraken system, and 18–24 months with Repel Pro underneath.
Safety
- The STARKE SDS lists Kraken as DANGER: flammable, may be fatal if swallowed and it enters the airways, and causes serious eye irritation. It may cause drowsiness or dizziness.
- Wear nitrile gloves and safety glasses.
- Use only outdoors or in a well-ventilated area. Keep away from heat, sparks and flame.
- California Prop 65 warning (methanol).
Watch it done
Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.




