Starke Elevate Medium Cut Compound is Step 2 (Refine) in STARKE's Surface Restore System. It removes the marks left by heavy compounding and 1200–1500 grit sanding scratches on gelcoat and paint, and finishes nearly swirl-free.

These directions follow STARKE's published product pages and Technical Data Sheets. Always read the label and Safety Data Sheet on your bottle, and test a small area first.

What you'll need

Before you start

Finish Step 1 first: Starke Level R Heavy Cut Compound on white wool with a rotary. Work on a clean, cool surface out of direct sun.

Step by step

  1. Work one 2 ft × 2 ft section at a time.
  2. Spread the compound across the section at low speed.
  3. Start around 1400 RPM and make 4 passes: 2 up and down, 2 side to side.
  4. Use moderate arm pressure, about 5 out of 10.
  5. Finish at about 1800–2000 RPM with the pad flat. Elevate responds well to heat and higher speeds.
  6. Wipe the section with a clean microfiber and check it in good light before moving on.

What comes next

Safety

  • The STARKE SDS lists Elevate as WARNING: may be harmful if swallowed, and causes eye irritation.
  • Wear safety glasses and nitrile gloves. Use with ventilation.
  • Keep the product moist while polishing to avoid dust, and avoid breathing polishing dust.

Watch it done

Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.

16 noviembre 2026 — Marine Detail Supply Team