How to Use Starke Level R Heavy Cut Compound
Starke Level R Heavy Cut Compound is Step 1 (Correct) in STARKE's Surface Restore System. It removes heavy oxidation, chalking and P600–P800 sanding scratches from gelcoat and marine paint. It's silicone-free.
These directions follow STARKE's published product pages and Technical Data Sheets. Always read the label and Safety Data Sheet on your bottle, and test a small area first.
Products in this guide
What you'll need
- Starke Level R Heavy Cut Compound
- A rotary polisher, such as the Makita 9237C Rotary Buffer or DeWalt DWP849X Rotary Polisher. STARKE says never attack oxidation with a random-orbital or dual-action polisher.
- A white wool pad, such as the STARKE Step 1 White Wool Heavy Cut Pad or Lake Country Double-Sided White Wool Pad
- Clean microfiber towels, nitrile gloves and safety glasses
Before you start
- Wash the boat thoroughly.
- If the oxidation is too heavy to compound out, start with STARKE Quik Sand on a white wool pad, or sand with P800 then P1000, before Level R.
- Work on a cool surface out of direct sun.
Step by step
- Prime a new pad by spreading compound across the surface first.
- Apply compound like toothpaste, in a thin, even layer.
- Work one 2 ft × 2 ft section at a time.
- Low and slow: start around 800 RPM. Starting too fast breaks the abrasives down too early and builds heat.
- Make 4 overlapping passes (2 up and down, 2 side to side) with firm arm pressure, about 7 out of 10.
- Bring the speed up to about 1200–1400 RPM and make the final pass with the pad flat.
- Wipe with a clean microfiber and check your work in good light.
What comes next
- Refine with Starke Elevate Medium Cut Compound on yellow wool, or go straight to Starke Finish R Hybrid Finishing Polish.
- Then protect with Starke Revolution Cleaner Wax, Starke Hyper Hold Pro or a STARKE ceramic coating. Freshly compounded gelcoat is completely unprotected.
Safety
- The STARKE SDS lists Level R as DANGER: may be fatal if swallowed and it enters the airways, and causes eye irritation.
- Wear safety glasses and nitrile gloves. Use with ventilation, not in confined areas.
- Keep the product moist while polishing to avoid dust.
Watch it done
- How to buff, polish and wax with flawless results (Level R, Finish R, Hyper Hold Pro)
- How to buff and compound a black boat (Level R, Elevate, Triple P)
- How to restore an oxidized boat: full gelcoat and non-skid process
Questions before you start? Call or stop by Marine Detail Supply Company Fort Lauderdale, 2821 SW 23rd Terrace, Unit 1, just off SR 84 near Marina Mile. Open Mon–Fri, 8am–4pm. (754) 732-1937. Orders over $200 ship free in the domestic US.




